Rigid Mount

A 2-piece Mount, separate upright and horizontal tubes joined by a corner/elbow connector. The upright tube is supplied with a 3” S-bend as standard to allow more precise positioning to be achieved and navigate around obstacles (trays, armrests etc.).

Overview

• A sturdy and cost-effective mounting solution.
• Allows the mount to be attached in a secure position and positions the device precisely where required.
• Can be repositioned using the locating pin on the UFCOP/IC1, allowing easy access for the user.
• Fits either side of the wheelchair.
• Suitable for most standard wheelchairs.
• Quickly removed from the wheelchair.
• Available with choice of Quick-release Base.
• Supplied as standard with 16” straight horizontal tune and 24” vertical tube with 3” S-bend. Different lengths of tube are available if required and can be specified with your order. Click here to see the range of available S-Bent tube.
• Suitable for devices up to 8kg.
• The upright tube must not be installed 15 degrees beyond vertical (forwards or backwards).
• NOT suitable for tilt-in-space wheelchairs. If tilted back it is possible for the mount to come loose and swing back towards the user.

Components*

• 1x Vertical S-Bent Tube (S24-3 as standard)
• 1x Horizontal Straight Tube (16" as standard)
• 1x 90 degree Tube Connector (TC90)
• 1x Frame Clamp Inner Piece (To fit specific wheelchair: standard is UFC1000IP with sleeves to fit 7/8" frame (UFC875IP) if no other clamp is specified)
• 1x Indexing Frame Clamp Outer Piece (UFCOP)
• 1x Index Clamp (IC1)
• 1x Quick Release Base (TUSB as standard)

* Components listed above are for standard configuration. Exact components may differ slightly to meet specific requirements.

Wheelchair Information and Custom Requirements

We ask for details of the Wheelchair the mount is intended to be used with in order to ensure that the supplied Frame Clamp is correct for that chair.